DT SWISS O.D.L., Техническое руководство

Страница: 43 / 62

O.D.L - Technical Manual
42
Installing the Remote Lever
V2016.10
6.3 Installing the Remote Lever
6.3.1 Installing the Remote Lever [Lightweight]
There are different DT Swiss remote levers available: The lightweight lever and the Two In One lever.
The lightweight lever can only operate a single DT Swiss fork while the Two In One lever can operate
a DT Swiss fork and a DT Swiss shock at the same time.
Both levers are available as single stage and double stage versions. O.D.L forks must be used in com-
bination with double stage levers.
Preparatory Steps Link
not required
Required Material Specification Amount
cable uncoated approx. 70 cm
cable housing Ø 4.2 mm approx. 55 cm
carbon fitting lubricant as required
General Information: Lightweight-Lever:
• The remote lever can only be used for DT Swiss forks.
• The remote lever can be installed on the right side or on the left side of the handlebar.
• The remote lever is designed for a handlebar diameter of 22.2 mm. If the diameter of the
handlebar is smaller, the clamp of the remote lever cannot be fixed strong enough.
1. Carbon handlebars: Apply a thin layer carbon
fitting lubricant to the contact area of remote
lever and handlebar.
2. Put the remote lever onto the handlebar and
tighten the fixing screw with a torque of 1.5 Nm.
3. Check the proper function of the remote lever and
the control elements next to it.
Neither the remote lever nor any other control
element may be affected in its proper function.
4. Push the remote lever in the position «open» (see
figure).
5. Cut the cable housing to the required length.
Check if the handlebar with the installed cable
housing can be turned without being affected.
6. Put the cable into the remote lever.
Only use uncoated cables!