DT SWISS O.D.L., Техническое руководство

Страница: 42 / 62

O.D.L - Technical Manual
41
Converting from Manual to Remote Operation
V2016.10
12. Turn the remote wheel into the lockout position
using the short end of an angled 2 mm Allen key.

The remote wheel is in the lockout position
when it touches the cable stop (see picture).
13. Screw on the fixing nut clockwise using an 8 mm
socket wrench (or ring spanner).
14. Tighten the fixing nut with a torque of 5 Nm.
15. Check the correct assembly of the remote wheel:
Turn the remote wheel with the short end of an
angled 2 mm Allen key.

The remote wheel must turn from the left stop
to the cable stop.

If the remote wheel cannot be turned in this
angle, the lockout pin is not positioned cor-
rectly. Dismount the remote wheel and posi-
tion the lockout pin again (see step 1,
page 39).
16. Check if the spring on the bottom of the compres-
sion wheel is mounted.
17. Put thread lock onto the thread of the fixing screw
of the compression wheel.

Required thread lock, see table on page 34.
18. Put on the compression wheel with the spring
facing downwards and screw on the fixing screw
using a T8 Torx key.
19. Tighten the fixing screw hand-tight with a max.
torque of 0.5 Nm.
Closing Steps Link
Install the remote lever. chap. 6.3, page 42
Check all functions of the fork.