DT SWISS O.D.L., Техническое руководство

Страница: 22 / 62

O.D.L - Technical Manual
21
Installing the Front Wheel
V2016.10
3.5 Installing the Front Wheel
Using a RWS Thru Axle
Check before every ride
Before every ride, ensure that the wheel is securely mounted in the fork. Ensure that the RWS lever is tightened
to at least 15 Nm.
Using a Quick Release
Install the front wheel in accordance with the instructions of the manufacturer of the quick release.
DANGER
Risk of injury due to collision of the tire with parts of the fork!
A collision test must be performed after the front wheel was installed!
DANGER
Risk of injuries due to damages of the fork caused by parts with sharp edges!
Mounting hubs, thru axles or quick releases with sharp edges can damage the fork. Such damages can
lead to a sudden failure of the fork.
• Check hubs, thru axles or quick releases for sharp edges.
• Do not use hubs, thru axles or quick releases if there are sharp edges.
Preparatory Steps Link
not required
1. Remove the axle from the fork and check it for sharp edges. If sharp
edges are present, the axle must not be used.
2. Clean and lightly grease the axle and the axle thread.
3. Clean the contact surfaces between the hub and the fork and check
for sharp edges. If sharp edges are present, the hub must not be used.
4. Position the wheel between the fork dropouts.
5. Push the axle through the dropouts and hub.
Closing the RWS:
1. Turn the lever in a clockwise direction and secure as tightly as possible
by hand (min. 15 Nm).
Lift the RWS lever (A), turn it to the required position (B) and let go
(C).
If a RWS plug-in is being used, the lever can be removed by pulling it
(D).
2. Check to ensure the wheel is secured correctly in the fork.
Opening the RWS:
1. Turn the RWS lever anti-clockwise.
(D)
C
B
A