Draytek Vigor2760, Руководство пользователя

Страница: 286 / 619

Vigor2760 Series User’s Guide 270
(PAP)
communicate with other routers or clients who need
bi-directional authentication in order to provide stronger
security, for example, Cisco routers. So you should enable
this function when your peer router requires mutual
authentication. You should further specify the
User Name
and Password of the mutual authentication peer.
The length of the name/password is limited to 23/19
characters.
Assigned IP Start Enter a start IP address for the dial-in PPP connection. You
should choose an IP address from the local private network.
For example, if the local private network is
192.168.1.0/255.255.255.0, you could choose
192.168.1.200 as the Start IP Address.
You can configure up to four start IP addresses for LAN1 ~
LAN6.
PPP Authentication
Methods Select the method(s) to be used for authentication in PPP
connection.
PPTP LDAP Profile Configured LDAP profiles will be listed under such item.
Simply check the one you want to enable the PPP
authentication by LDAP server profiles.
However, if there is no profile listed, simply click the link
of
PPTP LDAP Profile to create/add some new LDAP
profiles you want.
While using Radius or
LDAP Authentication If PPP connection will be authenticated via RADIUS server
or LDAP profiles, it is necessary to specify the LAN profile
for the dial-in user to get IP from.
After finishing all the settings here, please click OK to save the configuration.
3
3
.
.
1
1
0
0
.
.
3
3
I
I
P
P
s
s
e
e
c
c
G
G
e
e
n
n
e
e
r
r
a
a
l
l
S
S
e
e
t
t
u
u
p
p
In IPsec General Setup, there are two major parts of configuration.
There are two phases of IPsec.

Phase 1: negotiation of IKE parameters including encryption, hash, Diffie-Hellman
parameter values, and lifetime to protect the following IKE exchange, authentication of
both peers using either a Pre-Shared Key or Digital Signature (x.509). The peer that
starts the negotiation proposes all its policies to the remote peer and then remote peer
tries to find a highest-priority match with its policies. Eventually to set up a secure tunnel
for IKE Phase 2.

Phase 2: negotiation IPsec security methods including Authentication Header (AH) or
Encapsulating Security Payload (ESP) for the following IKE exchange and mutual
examination of the secure tunnel establishment.
There are two encapsulation methods used in IPsec, Transport and Tunnel . The Transport
mode will add the AH/ESP payload and use original IP header to encapsulate the data payload
only. It can just apply to local packet, e.g., L2TP over IPsec. The
Tunnel mode will not only