Dräger Savina, Инструкция по эксплуатации

Страница: 49 / 132

Configuration
49
Configuring the measured values line
Select one of 6 possible combinations of measured values:
●
Press » Config.
∆∆
« key repeatedly until
»Configuration 1/4« appears.
●
Select »Measured values« line = turn the rotary knob,
activate = press the rotary knob.
●
To set the measured values combination =
turn the rotary knob,
confirm = press the rotary knob.
The following combinations of measured values can
be selected:
Manual calibration for O
2
sensor 2
— once per month,
— if the following alarms occur:
!!! FiO
2
high
or
!!! FiO
2
low
or
!!! O
2
measurement inop.
Manual calibration can be carried out in the respective
ventilation mode:
●
Press » Config.
∆∆
« key repeatedly until
»Configuration 2/4« appears.
● Select »O
2
calib.« line = turn rotary knob,
to release for setting = press rotary knob.
● To start O
2
calibration = turn rotary knob and select
» Start «,
to confirm = press rotary knob.
Message in the information line on screen:
Disconnect patient
●
Disconnect patient within the next 30 seconds.
●
If necessary continue ventilating the patient using a
separate ventilating appliance.
1. VTe ftot MV
2. FiO
2
VTe MV
3. Ppeak VTe MV
4. Pmean FiO2 MV
5. Pmean VTe MV
6. Ppeak Pmean V
Te
0
7
8 3
7
388
0
7
6 3
7
388