The menu » Settings «
Page 58 of 72 Pages
9023927 - 2nd edition - May 2007
Sensor configuration
(using XS–NF
3
as an example
)
:
This group contains the setting functions for the sensor.
– Gas setting
— This function is used to change the settings for the gas to be measured.
●
Select the menu items » Settings «, » Sensor «, » XS–NF
3
« and » Set gas « in this
order, pressing the »
« key after each selection.
When several measuring gases of the sensor are displayed:
●
From the list of measuring gases use the »
« and »
« keys to select and the
»
« key to activate it.
— The selected gas is indicated.
●
Use the »
« and »
« keys to select the unit of measurement (e.g. ppm)
from the list and press the »
« key to activate it.
— The overview of the settings are displayed.
— If the settings are correct:
●
Use the »
« key to select the line » Confirm « and press the »
« key.
– Sensor initialisation
— This function is used to set all parameters of the sensors back to the factory de-
fault values.
●
Select the menu items » Settings «, » Sensor «, » XS–NF
3
« and » Sensor init. «
in this order, pressing the »
« key after each selection.
●
Select » Confirm « and press the »
« key to initialise the sensor.
– Set calibration interval
— This function is used to set the calibration interval.
●
Select the menu items » Settings «, » Sensor «, » XS–NF
3
« and » Set cal. int. «
in this order, pressing the »
« key after each selection.
●
Use the »
« and »
« keys to set each position of the calibration interval
(in days) and press the »
« key to confirm the setting.
To confirm the entered calibration interval:
●
Select » Confirm « and press the »
« key.
OK
M
OK
M
OK
M
OK
OK
OK
OK
M
OK
OK
