Installation Instructions for Wi-Q™ Technology 9KQ Cylindrical Locks
8
Installing the lock
BEST
a Product Group of dormakaba USA Inc.
9
Install lock chassis and engage
retractor in latch
From the outside of the door, insert the lock chassis
into the 2 1/8
″
chassis hole, routing the motor wire
through the notch.
Caution:
Make sure that the latch tube prongs
engage the chassis frame and that the latch
tailpiece engages the retractor.
10
Install the trim hole insert, bushing,
and hub washer on outside of door
1 On the outside of the door, insert the trim hole insert
into the upper trim hole, as shown in Figure 10.
2 Insert the bushing into the harness hole.
3 Slide a hub washer over the chassis sleeve so it rests on
the hub.
Inside of door
Figure 9 Installing the lock chassis and engaging the
retractor in the latch
Latch tube
prong
Retractor
Latch
tailpiece
Chassis
Chassis frame
Latch tube
prong
Notch
Outside of door
Figure 10 Installing the outside trim hole insert,
bushing, and hub washer
Trim hole insert
Bushing
Hub washer
Hub
Installation Instructions for Wi-Q™ Technology 9KQ Cylindrical Locks
7
Installation Instructions for Wi-Q™ Technology 9KQ Cylindrical Locks
Installing the lock
BEST
a Product Group of dormakaba USA Inc.
7
Remove outside lever or knob
1 Insert the control key into the core and rotate the key
15 degrees to the right.
2 Insert a flat blade screwdriver into the figure-8 core
hole and into the lever.
3 Press the screwdriver blade in the direction of the
arrow in Figure 7.
Note: You cannot remove the lever if the screwdriver
blade is inserted too far past the keeper.
4 Slide the lever or knob off of the sleeve.
Caution:
Be careful that you do not disconnect the
lever keeper spring.
8
Adjust for door thickness
1 Determine the door’s thickness.
2 Pull the rose locking pin and rotate the outside rose
liner until the proper groove on the through-bolt stud
lines up with the hub face.
Figure-8
core hole
Figure 7 Removing the outside lever
Lever keeper
Insert screwdriver
blade here.
Figure 8 Adjusting the rose liner for the door
thickness
1 3/4
″
2
″
2 1/4
″
groove
Through-
bolt stud
Hub face
Outside
rose liner
Rose locking pin
Motor wire
Содержание BEST Wi-Q ONGUARD
