Dormakaba BEST Wi-Q ONGUARD, Руководство пользователя интерфейса

Страница: 31 / 168

31
Proximity Card Check
If the Wi-Q Controller has a proximity card reader, the temporary operator card (supplied
with the controller) and the sign-on card (created in the WiQ Interface) are both required to
sign on the readers.
To perform a proximity card verification:
1 Select the temporary operator card supplied with the controller.
2 Present the temporary operator card to the proximity bezel at the face of the reader.
The light on top of the controller will flash green once and the lock will unlock. After 3
seconds, the controller will flash green and lock.
3 While unlocked, check for proper lock operation.
Keypad Check
If your Wi-Q Technology controller is a keypad type, perform the following steps:
1 At the keypad, enter the default Programmer ID, 1234#. The green light on top of the
card reader will flash once and the lock will unlock, then during the open delay time, it
will flash green five times. Once this occurs, the controller red light will flash and the
lock will relock.
2 While unlocked, check for proper lock operation.
Troubleshooting mortise and cylindrical locks
If the mechanism doesn’t unlock, refer to the following table:
Table 2. Troubleshooting (Mortise and Cylindrical Locks)
LEDs Sounder You should...
Single red flash — Use the card at a moderate speed.
Red flashes 3 short tones Use the temporary operator card provided with
the lock.
Green flashes — Check the motor connection.
— — Check the battery connection.