DOMUSA Fusion Hybrid Gas Condens, Инструкция по установке и эксплуатации

Страница: 48 / 76

Fusion Hybrid Gas Condens
Fusion Hybrid Gas Condens Fusion Hybrid Gas Condens
Fusion Hybrid Gas Condens
46
46 46
46
14 14 14 14 DRAININ DRAININ DRAININ DRAINING TH G TH G TH G THE E E E MODULE MODULE MODULE MODULE
The water is drained from the module by opening the air drain valve
(1
(1 (1
(19999))))
, located inside the module
on the lower left hand side of the heat exchanger. Connect a flexible tube to this valve and run it to a
drain. After draining the module, close the valve again and remove the flexible tube.
D
D D
During the draining process, it is recom
uring the draining process, it is recom uring the draining process, it is recom
uring the draining process, it is recomme
me me
mend
nd nd
nded t
ed t ed t
ed to
o o
o switch off
switch off switch off
switch off th
th th
the
ee
e module
module module
module and
and and
and
dis
dis dis
disconnect it from the mains.
connect it from the mains. connect it from the mains.
connect it from the mains.
15
15 15
15 SAFETY
SAFETY SAFETY
SAFETY INTERL
INTERL INTERL
INTERLOCKS
OCKS OCKS
OCKS
The module's electronic control system may activate the following safety interlocks to stop the
module's operation. When any of these interlocks occurs, the module stops working and an interlock
code appears on the display.
If any of the fo
If any of the fo If any of the fo
If any of the following
llowing llowing
llowing operating int
operating int operating int
operating interlocks are repetitive, turn off the
erlocks are repetitive, turn off the erlocks are repetitive, turn off the
erlocks are repetitive, turn off the module
module module
module and
and and
and
contact nearest official
contact nearest official contact nearest official
contact nearest official SAT
SAT SAT
SAT....
15.1 15.1 15.1 15.1 Temperature safety Temperature safety Temperature safety Temperature safety interloc interloc interloc interlockkkk
When this interlock occurs, the code "E07" "E07" "E07" "E07" and the error indicator symbol appear on the display.
The burner will switch off and stop heating the installation.
This occurs when the module exceeds a temperature of 100ºC. To unlock it, wait until the module
temperature drops to 85ºC and press the
RESET
RESET RESET
RESET button..
15.2 15.2 15.2 15.2 B B B Bu u u urn rn rn rner i er i er i er int nt nt nterlock erlock erlock erlock
When this interlock occurs, the code "E06"
"E06" "E06"
"E06" and the error indicator symbol appear on the display.
The burner will switch off and stop heating the installation.
This occurs as a result of an anomaly in the burner or in the fuel installation. To unlock, press the
R R R RE EE ESET SET SET SET button..
15.3 15.3 15.3 15.3 Low Low Low Low pressure interlock pressure interlock pressure interlock pressure interlock
When this interlock occurs, the code "E02"
"E02" "E02"
"E02" and the error indicator symbol appear on the display.
The burner and the module circulation pump will switch off, cutting off the heating and water flow
to the installation.
This occurs when the module pressure drops to below 0.05 MPa (0.5 bar), preventing the module
from functioning when the water is drained from the installation, due to either leakage or
maintenance operations. To unlock, press the
RESET RESET RESET RESET button..