DOMUSA Fusion Hybrid Gas Condens, Инструкция по установке и эксплуатации

Страница: 27 / 76

25
25 25
25
6 66 6 STARTING UP THE BO STARTING UP THE BO STARTING UP THE BO STARTING UP THE BOILER ILER ILER ILER
6.1
6.1 6.1
6.1 Prior warning
Prior warning Prior warning
Prior warningssss
Repair and maintenance of the module must be carried out by a qualified professional, authorised
by
DO
DO DO
DOMUSA
MUSA MUSA
MUSA TEKNIK
TEKNIK TEKNIK
TEKNIK . For optimum functioning and conservation of the boiler, it should be serviced
annually.
Please carefully read this instruction manual and keep it in a safe, easily-accessible place.
Before any servicing, disconnect the boiler from the mains and cut off the gas supply. Any
manipulation of the sealed parts of the boiler is prohibited.
DOMUSA TE DOMUSA TE DOMUSA TE DOMUSA TEKNIK KNIK KNIK KNIK will not be liable for any damages caused by failure to follow these instructions.
6.2
6.2 6.2
6.2 Fill
Fill Fill
Filling
ing ing
ing the domestic hot water tank
the domestic hot water tank the domestic hot water tank
the domestic hot water tank
The hot water tank must be filled before filling the heating circuit. Open the flow of domestic hot
water to the hot water tank, and turn on a hot water tap in the installation. When the tap begins to
run freely, turn it off, as this means the hot water tank is full.
6.3
6.3 6.3
6.3 Filling the heating
Filling the heating Filling the heating
Filling the heating circ
circ circ
circuit
uit uit
uit
The Fusi Fusi Fusi Fusion Hyb on Hyb on Hyb on Hybrrrrid Gas Cond id Gas Cond id Gas Cond id Gas Condens ens ens ens module is equipped with a filling disconnector. The heat pump
(external unit) includes a manual drain valve on the upper part of the heat exchanger flow tube
(condenser). Open it during the filling process and wait for the water to start running (please refer
to the operations manual of the
DUAL CLIMA
DUAL CLIMA DUAL CLIMA
DUAL CLIMA
heat pump). The air should also be bled from the rest
of the installation using the air bleed valves provided. The filling must be carried out slowly,
thereby facilitating air evacuation from the water circuit. Once the installation is full, close the
disconnector valves.
The Fusion Hybrid Gas Condens
Fusion Hybrid Gas Condens Fusion Hybrid Gas Condens
Fusion Hybrid Gas Condens module have a pressure sensor for controlling the pressure of the
installation. If it drops below 0.05 MPa (0.5 bar), a low pressure alarm (" E02 E02 E02 E02 ") will appear on the
display.").
: : : : Turning
Turning Turning
Turning on the module or the heat
on the module or the heat on the module or the heat
on the module or the heat pump with
pump with pump with
pump without water may cause serious damag
out water may cause serious damag out water may cause serious damag
out water may cause serious damage to
e to e to
e to
the equipment the equipment the equipment the equipment....
6.4 6.4 6.4 6.4 Gas Gas Gas Gas co co co con n n nnection nection nection nection
For the installation of any type of gas, the installer must be authorised by the Ministry of Industry
and strictly follow the applicable Gas Regulations. The gas installation must comply with the Gas
Installation Regulation (RIGLO).
However, the following recommendations must be complied with, at the least:
- Before installing the gas pipes, check the type of gas is compatible with the boiler.
- Check that the gas meter in the home can measure the rate of gas supply required.
- The gas pipe diameter is not determined by the boiler connection. It should be calculated in
accordance with its length and consequently its pressure drop.
- The pipes must be directly connected to the main gas supply pipe, not connected in parallel to
other gas appliances.
- Check there are no leaks from the installation.
- The gas supply company is the sole responsible for connecting the gas meter to the gas