6. Oscilloscope Function
6. Oscilloscope Function
6 - 5.
TIME / POSITION
Can set Waveform to the Horizontal Scale(time) by Encoder Switch.
To change waveform Position fast, press key longer than 2 seconds and
change position by Encoder switch. or press key and select time
and press key to enter the mode.
Display the horizontal Position
Changed by rotating Encoder
Time Ref
Left, Conter, Right
Time Base
YT, XY
Upper level menu
Sub menu
Function
TIME
Time
Position
Position
6 - 4.
Trigger Mode
Single shot, T’D AUTO, T’D NORMAL
Time
(Page 1/2)
When adjust Position, Position ICON should indicate to adjusted point. If Cursor
measurement is on Vertical axis its value is displayed.
Time Ref
(Page 1/2)
Time Position value is set Left(10%) Center(50%), Right(90%) Value.
Waveform Position ICON is displayed accordingly, If cursor measurement is
Performing on Vertical axis, its value is displayed.
Press key to display T’D AUTO(Triggerd Auto) T’D NORM(Triggerd
Normal) or SINGLE at top right area of display.
If waveform is acquired in SINGLE mode, STOP T’D NORM is displayed.
To acquire new waveform, press key to operate RUN.
Set 50%
function is explained in page 30
④
④
Trigger level.
6 -
6.
MEASURE
Use this function to utilize the various information regarding the currently
observed waveform. Values for the items listed above can be viewed. To display
on screen, press key and rotate ENCODER switch
to select measuring Function. Then, press key or
push down ENCODER to finish selection.
Frequency, Mean, Cycle Mean, RMS, Pk - Pk, Max, Min,
Amplitude, Top, Base, +(pulse) width, -(pulse) width, Rise
time, fall time, +duty, -duty, phase, delay, +Overshot, -
Overshot, preshoot
Top level menu
Sub menu
Measure
RUN/STOP
34
Hand-held Digital Oscilloscope Meter
35
