Docomo FOMA P706ie, Инструкция по эксплуатации, Страница: 402 / 577

400
Ne
two
rk Servi
ces
Before making a call, you can select a phone number to be notified to the
other party from the Function menu, and then make a call.
1
Enter a phone number
or
bring up the detailed display of a Phonebook entry,
redial item, dialed call record, or received call record.
2 i
( )
1
Multi number
1
Select a phone number.
≥
To cancel the additional number, select “Cancel prefix”.
You can check a phone number set for “Set multi number”.
1
m
1
Service
1
Multi number
1
Check setting
You can set a ring tone for calls that come in to the additional number.
1
m
1
Service
1
Multi number
1
Set as ring tone
1
Select an additional number.
Go to step 2 on page 92.
When the ring tone is set to “Same as ring tone”, the ring tone will be the one set for
“Phone” or “Videophone” of “Select ring tone”.
Set Own Phone Number when Making a Call
Information
≥
If you select “Basic Number” or “Additional Number1/2”, “
:
590 ＃ ”, “
:
591 ＃ ”, or
“
:
592
＃
” is added after the phone numbers.
Check Setting
Set as Ring Tone
You can use two phone numbers/mail addresses on your single FOMA
phone. By using respective modes, you can operate your FOMA phone
as if you are using two sets of them.
The following three modes are available with 2in1:
A Mode
You can use your phone number (Number A) to make calls and your i-mode mail
address (Address A) to send/receive mail messages, and can browse their related
data.
B Mode
You can use your 2in1 phone number (Number B) to make calls and access the sites
for Web mail (Address B), and can browse their related data.
Dual Mode
This mode has the functions of both A Mode and B Mode.
≥
For details on 2in1, refer to “Mobile Phone User’s Guide [2in1]”.
≥
Address B is used to send/receive mail messages via the dedicated Web mail site.
≥
You can use packet communication even in B Mode if you subscribe to i-mode.
≥
You can subscribe to either 2in1 or Multi Number.
≥
When you replace a UIM with another one (2in1 contractor → 2in1 contractor) while
using 2in1, perform “2in1 function OFF” (see page 401) and then set “2in1 setting” to
“YES”, or perform “Auto acquire No. B” (see page 370), to acquire the correct Number B.
When you replace a UIM with another one (2in1 contractor
→ 2in1 non-contractor),
perform “2in1 function OFF” as well to update the owner’s information to the correct one.
≥
See page 403 for how this service works for each mode.
1
m 1
Service
1
2in1 setting
1
Enter your Terminal Security Code
1
YES
When you activate 2in1, the 2in1 Setting Menu display
appears.
≥
This display appears also by pressing and holding
<
for at least one second from the Stand-by display and
entering your Terminal Security Code.
<2in1>
Using 2in1
Activate 2in1
2in1 Setting Menu display