Dish Network DuoDVR ViP 722k, Руководство пользователя

Страница: 126 / 171

116
Connecting to the Remote TVs (TV1 or TV2)
Chapter 12
Note : The remote TV(s) will have to be set to the same channel mode, either air or cable
mode, for this installation. See your TV user’s guide for instructions on how to set your TV
to air or cable channel modes.
4
Pick the channel in the middle of the three you selected in step 3. Write that channel down
in the blank provided in step 5. For example, if the three channels you picked in the
preceding step were air channels 60, 61, and 62, pick channel 61 and write it in the space
provided in step 5.
5
If your TV is in over-the-air mode for the channels you picked in step 4, circle “Air” below.
If your TV is in cable mode for the channels you picked in step 4, circle “Cable” below. If
you are using these instructions for TV1 and TV2, pick different channels (for example,
Channel 60 for TV1 and Channel 64 for TV2).
6
Set all of your remote TV(s) to the channel mode (air or cable) you circled in step 5.
7
Tune all of your remote TV(s) to the channel(s) you wrote down in step 5. This is the
channel that you will use to receive your satellite TV programming.
8
Connect CH 21-69 O
UT
on the receiver to your existing wall cable outlet using a coaxial
cable.
Note : If you do not have an existing in-home cable distribution system, you will need to
run coaxial cable to connect each TV located in other rooms. Due to the difficulty, you may
want to contact a professional to perform this installation.
9
Place the yellow sticker on the CH 21-69 Out cable near where the cable attaches to the
receiver. The stickers are located inside the front cover of this guide.
10
Turn on the nearby TV (the TV that is to receive programming from the TV1 outputs).
11
Make sure the receiver's green, front-panel indicator light for TV1 is on.
12
Press the MENU button. Select System Setup , Installation , and then Modulator Setup .
13
With the Modulator Setup screen displayed on the nearby TV, use Remote Control 1 to do
the following:
a
Under TV2 Out (or TV1 Out), select either Air (air channel numbers) or Cable (for
cable channel numbers) based on what you circled in step 5.
b
Under TV2 Out (or TV1 Out), use the UP and DOWN ARROWS to change the
modulator channel to the one you wrote down in step 5.
c
Select Done .
Note : For TV1 O
UT
, if you locked the receiver, a message will be displayed asking you
to enter the password.
TV1 Channel: Air / Cable TV2 Channel: