Dish Network DuoDVR ViP 722k, Руководство пользователя

Страница: 106 / 171

96
Tips
Chapter 10
T
IPS
• If using a specific channel for TV2 (for example, channel 60), TV2’s remote control
must be programmed with a TV2 channel before you can use the RECOVER feature.
• Place the channel sticker on the remote TV (TV2) and write down the channel set up
to watch DISH satellite programming. These stickers are inside the front cover of this
guide.
• If you don’t want to accidentally change channels on your TV (or VCR, if applicable),
then you may place the remote control in Limited Mode, as described on page 78.
• Make sure you have a remote control antenna connected so you can use Remote
Control 2. See page 17 for instructions.
Q
UESTIONS
• My remote doesn’t control my receiver or other components. What should I do?
– Make sure the remote control is in the correct device mode (page 78).
– Check that the batteries are working and installed correctly (page 17).
– Check the receiver and remote control address (pages 75 and 84).
– Check (page 17) or adjust (page 76) the remote control antenna connection.
• Why does my receiver change channels or display menus at random? A
neighbor may have DISH remote control set on the same address. Change the
address on your new remote control and receiver as described on page 74. If that
doesn’t fix it, you may have to install a UHF attenuator as described on page 77.