t
Reflex Duplicator Manual
- 13 -
How to make copies from the Hard Drive?
When you turn on your duplicator, after it has booted up, you
should see the following signifying your duplicator is ready.
1. Make sure the Master Reading Source is set to the Hard
Drive.
It is very important to make sure the Master Reading Source
is set to the Hard Drive in order to avoid unnecessary error
messages. To check the Master Reading Source, please do
the following:
Use UP or DOWN arrow button to navigate to the following
screen.
a. Press “ENT“ to enter Select Source Menu and you shall
see the following:
Make sure it is located at “Hard Drive“. If not, then you
need to press UP or DOWN navigation button to search
for it.
b. Press “ENT“ to submit your selection. After your
selection has been submitted, you will see the following:
Hard Drive Port 0
WDC WD400EB-75CPF0
Disc Makers .99
1. COPY
Setup
5.2 Select Source
t
Reflex Duplicator Manual
- 14 -
2. Load your master disc onto the Hard Drive. If you have
already loaded your master disc onto the Hard Drive, then
you can skip step 2 and go to step 3.
a. Use UP or DOWN arrow button to navigate to the
following screen.
Press “ENT“ to enter Hard Drive Setup Menu and you shall see
the following:
b. Press “ENT“ to enter Load Partition Menu and you
shall see the following:
c. Now, you have a choice to load your master disc into a
new (empty) partition or overwrite one of the existing
partitions. Press UP or DOWN arrow button to select your
Setup
5.2 Select Source
Image
3.2 Load Partition
Load Partition [ 1/ 8]
Load->New Partition
*The “1” indicates the number of partitions
you’ve already loaded into the Hard
Drive . (Includes the Reserve Partition)
*The “8” indicates the total number of partitions
you can load to the Hard Drive.
