DINSE DIX PI GO 2006.M, Руководство по эксплуатации

Страница: 14 / 36

14
Control panel
Welding Power Source
Introduction 14
Control panel 15
KEY AND KNOB COMMANDS 15
DISPLAY AND LED INDICATIONS 16
Switching on the welding machine and initial screen 16
Viewing the software version installed 16
Loading of the wire 17
Special functions “Fx” 17
SETUP Menu 19
FACTORY DEFAULT (FAC) 19
TIMER ARC ON 19
TIMER WELDING MACHINE ON 19
ERROR LOG 19
TEST 20
Menu SPECIAL FUNCTIONS 21
SAFETY CALIBRATION CODE (SCC) 21
MOTOR CALIBRATION (Mot CAL) 21
ARC LENGTH ADJUST 22
SWITCH 22
WATER COOLING MODE 22
PASSWORD 23
BLOCKS 23
SERIAL NUMBER 23
MIG-MAG synergic / MIG pulse / double pulsed MIG 24
1 - WELDING PROCESS SELECTION 24
2 - SELECTION OF WELDING PROGRAMME 24
3 - WELDING MODE SELECTION 25
4 - SPECIAL FUNCTIONS “Fx” SELECTION 25
5 - PRE-SETTING 26
6 - WELDING 26
7 - HOLD 26
MIG-MAG manual 27
1 - WELDING PROCESS SELECTION 27
2 - WELDING MODE SELECTION 27
3 - SPECIAL FUNCTIONS “Fx” SELECTION 27
4 - PRE-SETTING 28
5 - WELDING 28
6 - HOLD 28
Special processes 29
Electrode (MMA) 29
1 - WELDING PROCESS SELECTION 29
2 - SELECTION OF WELDING PROGRAM 29
3 - SPECIAL FUNCTIONS “Fx” SELECTION 29
4 - PRE-SETTING 30
5 - WELDING 30
6 - HOLD 30
7 - ACTIVATING THE VRD DEVICE 31
TIG with “Lift” striking 31
1 - WELDING PROCESS SELECTION 31
2 - SPECIAL FUNCTIONS “Fx” SELECTION 31
3 - PRE-SETTING 32
4 - WELDING 32
5 - HOLD 32
JOB 33
1 - CREATING AND SAVING A JOB 33
2 - JOB SELECTION 33
3 - PRE-SETTING / VIEWING MEMORISED JOB
DATA 33
4 - WELDING 33
5 - HOLD 34
6 - MODIFICATION AND OVERWRITING OF A
MEMORISED JOB
34
7 - DELETING A JOB SAVED 34
Error condition 34
Introduction
This section of the operating manual contains all the necessary in-
formation for the best possible use of the control panel. This con-
trol panel is especially for multi-process welding machines with:
MIG-MAG, MIG PULSE, MIG DOUBLE PULSE, MMA and TIG
welding processes.