Dinolift DINO 120T, Руководство по эксплуатации

Страница: 46 / 65

46
Operating instructions
•
DINO 120T
•
120TB
5.5. IN CASE OF EMERGENCY
5.5.1. When at risk of losing the stability
Reduced stability can be caused by a fault in the lift, the wind or other lateral force, collapse
of the standing base or negligence in providing sufficient support. In most cases one sign of
reduced stability is the inclination of the lift.
1 2
3 4
1. If there is time, try to find out the reason for the reduced stability and
the direction of its effect. Warn other people on the worksite using the
alarm signal.
2. If possible, reduce the load from the platform in a safe manner.
1 2
3 4
3. Reduce the outreach to the side by retracting the telescope. Avoid
abrupt movements.
4. Turn the boom away from the danger zone, i.e. to a position where the
stability of the lift is normal.
5. Lower the boom.
If the stability has been lost as a result of a fault in the lift, repair such a fault immediately.
Do not use the lift until the fault has been repaired and the condition of the lift
has been verified.
5.5.2. In case of overloading
1 2
3 4
1. If there is time, try to find out the reason for the reduced stability and
the direction of its effect. Warn other people on the worksite using the
alarm signal.
2. If possible, reduce the load from the platform in a safe manner.
1 2
3 4
3. Reduce the outreach to the side by retracting the telescopic boom using
the emergency descent system. Avoid abrupt movements.
5.5.3. In case the power supply is interrupted
As a precaution against power failure or other
malfunction of energy supply, the lift is equipped
with a manually operated emergency descent
system.
Always check the condition of the emergency
descent system before starting to use the lift.
NOTE! Using the emergency descent, retract
first the telescope completely, then lower the
articulated arms and the boom, and finally, turn
the boom.
The lever for the hand pump (A) is located on
the right-hand side of the chassis control centre.
The crank for turning the boom (B) is located on
the left-hand side of the chassis control centre.
B
A