Dinolift DINO 120T, Руководство по эксплуатации

Страница: 35 / 65

35
5.2. OPERATION
Carry out all the daily maintenance routines and inspections in accordance with the
maintenance instructions before operating the lift.
Failure to check the safety devices
may cause a serious injury or make the consequences of an accident worse.
DANGER
WARNING
CAUTION
NOTICE
5.2.1. Operating the lift from the chassis control centre
1. Turn the selector switch Q1 to the position LCB – chassis control
centre.
Piirustuksen numero
VILAKONE OY
Tulostus pvm.
Revisio
Kpl/kone
Ohjetarra, joystick
1
41603606
2. Select the movement speed using the speed selector switch. Drive
the boom and the platform using the control levers in the chassis
control centre:
4CB4054
Koko 243x339 mm
Nimike 4CB4054
Logo muutettu uudeksi 29.5.2015 VR
Nopeusvalintasymbolit muutettu 7.3.2016 LKö
V
- extending and retracting the telescope
- lifting and lowering the boom
- turning the boom
The movement will stop as soon as the speed selector switch or the
selector switch for the movement is released.
3. Before starting the operation, lift the platform from the tow-bar and
turn it to the side so that you can lower the boom.
4. Extend the telescope as much as is necessary to ensure that
stepping onto the platform is safe.
Do not damage the tow-bar jockey wheel!
DANGER
WARNING
CAUTION
NOTICE
The boom movements are noticeably slower when operated using the emergency descent
system.
If the lift is operated from the chassis control centre, the speed of the boom movements
cannot be adjusted continually using the control levers.
Adjusting the position of the platform from the chassis control centre:
The levelling system of the platform will automatically keep the
platform level during the movements. As necessary, the position
can be corrected.
Carry out the levelling of the platform while the lift is in the
support position (the outriggers down). Adjust the platform
position with the boom on a level. No persons allowed on the
platform during adjustment.
4CB4054
Koko 243x339 mm
Nimike 4CB4054
Logo muutettu uudeksi 29.5.2015 VR
Nopeusvalintasymbolit muutettu 7.3.2016 LKö
V
The position of the platform may be adjusted from the chassis control panel:
1. Turn the selector switch Q1 to the position LCB.
2. Turn the speed selector switch.
3. Select the direction of the correction movement using the control lever (9).