5. Press the ENTER Key
to program the selected CV value into the
selected CV number.
6. Press the EXIT Key
to quit programming mode and return to
normal operations.
You can program as many CVs and their values as you want in a session.
When you are finished, press Press the EXIT Key
to quit pro-
gramming mode and return to normal operations.
7. With ops mode programming, the command station does not turn off
track power. If you are using a DB150, you do not need to turn
track power back on after programming with ops mode like you do
with service mode programming.
13.5 Busy or Fail Message
If you get a “Busy” message in response to any programming task, the
system is temporarily busy and you will have to try the task again
until you get a “Good” response.
If you get a “Fail” message in response to any programming task, check
to be sure that there is a loco on the programming track and that the
programming track is powered.
E X I T
E X I T
E N T E R
This display shows a typical operations
mode programming screen:
1. Po in the Mode Indicator Area shows that we
are in Operations Mode Programming
2. 0597, the address being programmed appears
in the lower right corner.
3. CV Number 004 (deceleration)
4. CV Value of 003 (a moderate amount of deceleration)
5. The symbol indicates that the left side of the display
is active meaning that any key pad entry made
will show in the CVNo area of the display.
51
