Remember that you can click the R Throttle to toggle the CV value
display between decimal and hex as shown below.
6. To access CVs 513 and above for stationary decoders simply press
the R Reverse Key
. In this range of addresses, use the L throt-
tle knob to dial up the stationary decoder CV# and the R throttle to
dial up the stationary decoder CV value.
7. Press the ENTER Key
to program the selected CV value into the
selected CV number.
8. Press the EXIT Key
to quit programming mode and return to nor-
mal operations.
You can program as many CVs and their values as you want in a session.
When you are finished, press Press the EXIT Key
to quit pro-
gramming mode and return to normal operations.
9. If your command station is a DB150 and you are using any method
other than Operation mode for programming, you will need to turn
track power back on after you complete programming. Press the
PWR Key, then press the Y+ Key, then press the PWR Key to exit
power mode. DCS100 does not require this step.
E X I T
E X I T
E N T E R
R
Press the R Throttle Knob to display
CV value of 045 decimal as x2D hex
Use Paged Mode (P
G
) to
Program CV02-Start Voltage
To a CV value (dAt) of 045 (decimal)
The symbol indicates that values entered
by turning the R throttle knob or entering
numbers from the keypad will appear in this
side of the DT400's display.
49
