train or one unit can be the mid train helper or a pusher on the end
of the train.
4. Before consisting the locos, make sure that both are traveling in the
SAME PHYSICAL DIRECTION ON THE TRACK
. (The direc-
tion indicators may or may not match, the important thing is that the
locomotives are set up to move in the same direction and are not
pulling against each other.)
5. Press the MU Key
, the display will show the following:
the MU mode indicator on the
LCD display is lit. The loco
address in the L side of the
display will blink to show that
it is the address that will be
consisted to the address on the
R Throttle.
6. The DT400 display will prompt you to press the Y + Key
to
add the loco address or the N - Key
to remove the loco address
from the consist controlled by the TOP loco address selected on the
R Throttle. You will see the LCD alternate between the following
two screens to remind you of which key to press.
7. Press the Y + Key
to add the left address to the consist.
The L Throttle display shows the address of the loco that was added to
the consist with a cn in the text line above it. The R Throttle display
shows the address of the TOP loco address and its current % of full
speed. The R Throttle is now in control of the speed & direction of
both locomotives in the consist.
You can access the functions of the any loco in the consist by selecting the con-
sisted loco to a throttle and using the function keystrokes outlined in Section
Y
+
N
Y
+
M U
40
