Note: DT400 can access F0-F12 when used with DCS50 or DCS100 Command
Stations. DT400 can access F0-F8 when used with DB150 Command Station.
4.22 Infrared Emitters
Your DT400 has two infrared LEDs in the cable end of the throttle. These
emitters send infrared signals that can be used by LocoNet compatible Infrared
receivers to give you tetherless operation. See Section 21 for infrared opera-
tion information.
5.0 Track Power On/Off
5.1 Track Power On
When track power is on:
DT400’s Track Power Indicator is on (small dot in the top line on the
right side of the LCD)
Command Station TRACK STATUS indicator is lit and
Command Station OFF LINE indicator is off.
To turn track power on: Press the PWR Key
the LCD will display a
screen similar to this:
Press the Y + Key
to turn on track power. Press the PWR Key again to
exit Power On/Off Mode. You may also press any other key to go directly to
the next throttle task you wish to perform.
If you press the Y + Key
two times, you will see the DT400 Track Power
Indicator blink to indicate that the system is in “STOP” with track power on.
Simply press the Y + Key
a third time to toggle back to system “GO” and
track power on.
Y
+
Y
+
Y
+
This display shows a DT400 in PWR mode.
1. Track power is currently on.
2. The L throttle does not have a loco selected.
3. The R throttle is running address 25 in the
forward direction at 50% speed.
4. Press the Y+ Key to turn track power on.
Track Power Indicator
PWR
27
