3. If the Mode indicator does not show Fn, press the FUNC Key
once to enter the function mode for the active throttle. The Mode
Indicator in the center of the lower line on the LCD will show Fn
(function mode).
10.1.1 Function 0 (F0)
Press the LAMP 0 Key
to toggle F0 between on and off. Each
time the LAMP 0 Key
is pressed while in function mode, F0
will change from off to on or vice-versa. The top line of the LCD
will display a 0 when the F0 is on and will be blank when F0 is off.
F0 is most often used for reversing head lights but can be set up for
other functions as well.
10.1.2 Function 1, 3, 4, 5, 6, 7, 8, 9, 10, 11, & 12
Press the button on the numeric keypad that corresponds with the
function you want turn on/off. The top line of the LCD will display
the numbers of the functions that are on for the active loco address.
F1 is labeled with a bell icon to remind you that this is the preferred
function for bell operation and F3 is labeled with a coupler icon to
remind you that its preferred function is coupler operation.
Note: DT400 can access F0-F12 when used with the DCS50 or DCS100
Command Station. DT400 can access F0-F8 when used with a
DB150 Command Station.
10.1.3 Function 2 (F2)
Press the Horn 2 Key
on the numeric keypad. F2 is labeled
with a whistle icon to remind you that this is the preferred function
for whistle or horn operation.
F2 is a special non-latching function
. This means that F2 can be used
to control a whistle or horn sound from the decoder. It will only
sound when F2 is being held down. This lets you vary the length of
time that the whistle blows, just like the prototype.
2
0
0
FUNC
37
