XTLplus Series Installation and Programming Guide | Digital Monitoring Products
17
NETWORK OPTIONS
Network Options
This option is for configuring the desired network settings. This information will be used
during communication of messages via network.
Note:
IP addresses and port numbers may need to be assigned by the network
administrator. When entering an IP, Gateway, or Subnet Mask address be sure to
enter all 12 digits and leave out the periods.
Wi-Fi Setup (XTL+W/XTL+WZ Only)
This option is for connecting to the desired Wi-Fi network and will display only when
the Communication Type is set to Wi-Fi. See
. Press any Select Key
or Area to select. WPS LIST MANUAL displays. Press
CMD
to display TEST.
▶
WPS
automatically connect to a WPS enabled router.
▶
LIST
displays the name and signal strength of any Wi-Fi routers in range.
▶
MANUAL
enter the name of the Wi-Fi router you wish to connect to.
▶
TEST
verifies the connection of your system to the Wi-Fi network.
On Graphic Touchscreen Keypads with Version 110 or higher connected to a panel
running Version 172 or higher, a Wi-Fi status icon will display at the top of the keypad
when the system is connected to the network.
WPS
When WPS is selected, SEARCHING displays. Press the WPS button on the Wi-Fi
network router to which you are attempting to connect. SEARCHING displays for up
to two minutes or until connected to the WPS enabled router. Refer to the router’s
instruction manual for sending a security key to the XTLplus Series panel.
If the panel fails to connect to the WPS enabled router, WPS FAILED RETRY? NO YES
displays. Press the fourth Select Key or Area to RETRY or press the third Select Key or
Area to display WPS LIST MANUAL.
List
When
LIST
is selected, SEARCHING displays until any Wi-Fi networks are found in
range. Once available Wi-Fi networks are found the keypad displays the name of the
SSID (Wi-Fi Network name) and signal strength of each network. Press
CMD
to scroll
through the list of available Wi-Fi networks. When the desired network is displayed,
press any Select Key or Area to connect.
Manual
This option allows you to enter the desired network name using the keypad. When
MANUAL is selected, the current settings display. Press
CMD
to continue with no
change.
SECURECOM
is the default.
Enter up to 32 characters for the SSID from the network router to identify the network
LAN. The SSID is blank by default. Use the chart below to enter lowercase or special
characters. Each successive press of the Select Key or Area gives additional options.
For example, to enter Me5%, you would press 5, Select Key or Area 1 (M); press 2, Select
Key or Area 2 twice (e); press 5; press 7, Select Key or Area 4 twice (%).
When \ is entered, the keypad displays ¥. When ~ is entered, -> displays.
NUMBER
SELECT KEY OR AREA 1
SELECT KEY OR AREA 2
SELECT KEY OR AREA 3
SELECT KEY OR AREA 4
1
A, a,
B, b
C, c
(, [, {
2
D, d
E, e
F, f
), ], }
3
G, g
H, h
I, i
!, ^, ~
4
J, j
K, k
L, l
?, ", |
5
M, m
N, n
O, o
/, \, `
6
P, p
Q, q
R, r
&, $
7
S, s
T, t
U, u
@, %
8
V, v
W, w
X, x
, =
9
Y, y
Z, z
space, :
_, ;
0
-, +
., '
*, <
#, >
NETWORK OPTIONS
WI-FI SETUP
WPS LIST MANUAL
TEST
SIGNAL
▐▐▐▐▐▐▐
HOMENET123
Table 2: Entering Lowercase or Special Characters