Digital Equipment RW504-ZA, Руководство по обслуживанию

Страница: 39 / 220

2.8.2 Shipping the RW504/RW524 Optical Disk Library
If the disk library must be shipped, do the following steps.
1. Unmount (unreserve) any disk surfaces from the host system if necessary.
2. Eject all disks from the autochanger and, if the disks were not labeled with a
storage slot location prior to inserting them into the autochanger, do it now.
CAUTION
Failure to eject all disks from the optical drive and storage slots prior
to transport could result in damage to the drive mechanism, the
autochanger, or both.
3. Run
TEST 23
to position the picker for shipping.
a. Press
NEXT
until
TEST *
appears, and then press
ENTER
.
b. Press
NEXT
until
TEST 23
appears, and then press
ENTER
.
CAUTION
Do not switch off power or unplug the AC power cord from the optical
disk library until you are sure that the SCSI bus is inactive. Switching
off the library or unplugging the power cord when the SCSI bus is active
can cause data loss, indeterminate bus states, or both. (Check the host
system reference manuals for information on checking the status of the
SCSI bus.)
4. Press the operation button (located on the optical disk library front panel) and
the power switch (located on the back panel) so they are both in the ‘‘OFF’’
position.
5. Remove the power cable and SCSI cable connections from the optical disk
library.
6. Lay the disk library on its side and replace the shipping screw (See
Figure 2–4).
Environmental/Installation/PM 2–13