2–14
Installing Your System
To load a disc:
1. Examine the disc caddy. Make sure it is not cracked or damaged.
Never load a damaged caddy into a compact disc drive.
2. Align the disc caddy with the drive as shown
1
. Make sure the label
on the disc is facing up when you insert the disc in the drive. Also
make sure the notches on the left side of the disc caddy line up with
the notches on the door of the drive.
NOTE
If the disc label is facing up and the notches are on the right,
then the disc is loaded improperly in the caddy. Stop loading
the disc and refer to Appendix D.
3. Slide the caddy in the drive as far as it will go
2
, then remove it
3
. When you remove the caddy, notice that the disc and its
housing
remain in the drive. Only the
transparent sleeve
comes out.
The green activity light should turn on within 5 seconds.
If the activity light does not turn on:
If the drive accepted the
disc and caddy, then the disc may be sitting incorrectly in the caddy.
Remove the disc and check that the label is facing up when you insert
the disc into the drive again. If the activity light still does not come
on, there may be a problem with the RRD40 drive. Contact your local
Digital service representative.
