2
Installing Your System
Setting up your InfoServer 100 system is easy. This chapter provides
step-by-step instructions on how to:
• Prepare for installation.
• Unpack, inspect, and check the system’s equipment
• Set up your system unit.
• Attach Ethernet terminators for networking or diagnostic tests.
• Connect a terminal.
• Load and unload compact discs.
• Start your system.
Choosing the Right Location
Use the following checklist to keep your system operating at its best:
• Carefully read all installation instructions before you turn on the
power.
• Keep the air well circulated to prevent excess heat and dust from
accumulating.
• Keep your equipment away from heaters, photocopiers, direct
sunlight, and abrasive particles.
• Before you set up your system, select a surface that is large enough to
hold the system unit. Your desk or work table is a good choice.
• Keep the area clean. Do not place food or liquid on or near your
equipment, and do not place your system unit directly on the floor.
Dust and dirt will damage the system components.
• Keep air vents clear on each side of the system unit for proper
ventilation.
2–1
