2–4
Installing Your System
Setting Up Your System
After unpacking, you are ready to set up your server.
Identify the System Unit Ports and Connectors
The following figure shows all the ports and connectors on the rear of an
InfoServer 100 system. Take some time to become familiar with the ports
and connectors. Symbols (called icons) identify each port and connector
you will use when installing your system.
On/Off Switch
System AC Power
SCSI Port
Standard Ethernet
Connector
Standard Ethernet Light
Network Select Button
ThinWire Ethernet Light
ThinWire Ethernet
Connector
Halt Button
MMJ Ports
Break Enable Switch
(For Field Service Use Only)
Diagnostic LEDs
1
L J - 0 0 0 5 5 - T I 0
M M J P o r t
( N o t U s e d )
NOTE
Not all of the connectors shown are usable. In particular, MMJ
ports 2 and 3 and the modem port (to the left of MMJ port 1) are
not supported by the server.
