Digital Equipment DECrepeater 90FS, Руководство по установке и настройке

Страница: 45 / 80

DECrepeater 90FS Installation and Configuration 37
Configuring the Module (Cont.)
[10] Downline Upgrade (Cont.)
The following section explains how to use the DLU process. An (expanded) example
of the setup screen displays follows the description.
Using the DLU Process
Before initiating this option, be sure that the module that you are upgrading has been
configured with an IP address. If the module is not configured with an IP address,
select the
Set In-Band Interface IP Address
option (option
[8]
) from
the
DECrepeater 90FS INSTALLATION MENU
to set an IP address.
Do not use the DEChub 900 MultiSwitch Hub Manager’s IP address to upgrade the
DECrepeater 90FS.
When you select the
Downline Upgrade
option (option
[10]
) from the
DECrepeater 90FS INSTALLATION MENU
, the initial setup screen display
appears (see the following example display). This screen identifies the option and
alerts users not to interrupt power during the downline load.
Enter selection : 10
DECrepeater 90FS
DOWNLINE UPGRADE
This process upgrades the device’s firmware (in
nonvolatile Flash memory). Enter the IP address of
your TFTP (Trivial File Transfer Protocol) load host
and the image file name when prompted.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* IMPORTANT! IMPORTANT! IMPORTANT! *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* If power is interrupted during the downline load, the *
* firmware image can be corrupted. Do not turn off power *
* to the unit or perform any action that can cause the *
* unit to lose power during a downline upgrade. *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
... Press Return Key to Continue ...