Digital Acoustics TalkMaster FOCUS, Справочное руководство

Страница: 46 / 101

TalkMasterFOCUSAdminConsoleReferenceManual
40
Server-Peer Settings - These options are available when configuring a Direct Mode Server . For more
details on direct mode configuration, refer to the Application Note - Direct Mode Configuration included
with the software documentation.

No Beep Tone After PTT Released - check this box to prevent a beep from being played at the
end of a Talk session.

Default To Listen - check this box to have the Server automatically monitor the Client Intercom.

Server-Peer Hands Free - checking this box causes the Client Intercom's Talk button to "dial"
the Server Intercom. The Server Intercom answers by pressing and holding the Talk button.
When the Server's Talk button is released, the Client Intercom can respond "hands-free".
Audio Settings - These options are used to change some of the IP7audio defaults.

Disable AGC - Check this box to disable the IP7's Microphone AGC (Automatic Gain Control).
The Microphone's AGC attempts to amplify soft sounds and soften loud sounds. In certain
environments, it may be necessary to turn this feature off. When the AGC is turned off, a fixed
amount of Mic Gain must be specified as a number between 0 and 63. When specifying Mic Gain,
try making changes in increments of 25% and adjust as necessary.

Default Microphone - Select the default audio codec to be used to be used when the IP7's Talk
switch is depressed. The IP7's microphone supports sending uLaw or PCM audio. Older ii3
Intercoms only support sending PCM.

Please note that this only applies when the IP7's Talk switch is pressed. This does not apply
when the IP7's microphone is activated via software or if the IP7 has been configured with the
Call Button option.
Audio Profile - This option is only available on new IP7's that support Acoustic Echo Cancellation (AEC).
The manual included with the hardware may recommend one or more Audio Profiles based on the
environment it is installed in.

Press the Set button and select a profile from the dialog. Press the Done button to apply the
audio profile