Digital Acoustics TalkMaster FOCUS, Справочное руководство

Страница: 33 / 101

27
IP Endpoints Tab
IP Endpoints
The IP Endpoints tab is used to discover and configure all IP Intercoms/Paging Endpoints connected to
the current network. Once discovered, they can be configured as a Client connecting to the TalkMaster
Server and/or Registering to a SIP server.
Initially, the Intercom list will be empty. Press the FIND ALL button to discover any new IP Endpoints
that have been added to the network to populate the IP Endpoint list. All IP Endpoints must initially be
discovered on the network in order for them to be configured.
Click the Find All button to discover IP Endpoints as follows:

The Server will issue both a UDP Broadcast and a UDP Multicast discovery request to
discover any new IP Endpoints. IP7 series devices in Multicast capable subnets will respond
with a UDP packet to the Server with their device configuration and will be added to the list of
IP Endpoints. ii3 series devices (and IP7 series devices that are not in a multicast capable
network) in the same network segment as the Server will respond by sending a UDP
Broadcast with their device configuration and will be added to the list of IP Endpoints

If an IP7 IP Endpoint was not discovered because it was in a non-multicast capable subnet but
the device's IP Address is know, use menu option
Tools-->Find Device By IP Address and
Tools--> Save Device By IP Address to discover and configure the device

If the IP Endpoint was not discovered and the IP Address is not known, install TalkMaster on a
laptop or PC in the same subnet as the device to perform the initial configuration

Once a device has been configured to connect to the Server, the device's configuration will
always be available through its TCP connection to the Server

Once an IP Endpoint has been discovered, it will remain in the list on the IP Endpoints tab until
it is deleted
If an IP address is listed as Remote , the device is an ii3 device and cannot be configured from this
Administrator Console. If appropriate, refer to the installation CD for instructions on installing the UBAM
software which will allow configuration of older ii3 IP Endpoints across different network segments.
If an IP address is listed as Disconnected , the intercom is turned off, not connected to this Server or not
operating correctly.
T he IP Endpoints tab is composed of four sub-tabs General, WiFi , eSIP and ZC and each of these has
multiple sub-tabs. Changes made on the General, WiFi, eSIP and ZC sub-tabs are applied when the
Save button is pressed. Depending on the IP Endpoint model, it will take 10 to 40 seconds for the
changes to take affect.
The IP Endpoints are listed in ascending order by Auth / Location Name / Icom ID. IP Endpoints that are
not authorized will appear at the top of the list, sorted by the Icom ID. Click any one of the column
headers to resort the IP Endpoint list.