Digisol DG-FS4528P, Руководство по управлению

Страница: 271 / 973

C
HAPTER
8 | Interface Configuration
Configuring Rate Limits
– 271 –
C
ONFIGURING
R
ATE
L
IMITS
Use the Port > Rate Limit pages to apply rate limiting to ingress or egress
ports or trunks. This function allows the network manager to control the
maximum rate for traffic received or transmitted on an interface. Rate
limiting is configured on interfaces at the edge of a network to limit traffic
into or out of the network. Packets that exceed the acceptable amount of
traffic are dropped.
Rate limiting can be applied to individual ports or to trunk groups. When an
interface is configured with this feature, the traffic rate will be monitored
by the hardware to verify conformity. Non-conforming traffic is dropped,
conforming traffic is forwarded without any changes.
CLI R
EFERENCES
"Rate Limit Commands" on page 711
P
ARAMETERS
These parameters are displayed:
Port/Trunk – Displays the port/trunk number.
Rate Limit Status – Enables or disables the rate limit.
(Default: Disabled)
Rate Limit – Sets the rate limit level. (Range: 64 - 100,000 kbits per
second for Fast Ethernet ports; 64 - 1,000,000 kbits per second for
Gigabit Ethernet ports)
W
EB
I
NTERFACE
To configure rate limits:
1. Click Port, Input Port Configuration (or any other rate limit page).
2. Enable the Rate Limit Status for the required ports.
3. set the rate limit for the individual ports.
4. Click Apply.