Digi AnywhereUSB Plus, Руководство пользователя, Страница: 670 / 815

Virtual Private Networks (VPN) L2TPv3
AnywhereUSB® Plus User Guide 670
1. Log into the AnywhereUSB Plus WebUI as a user with Admin access.
2. On the menu, select Status . Under VPN, select L2TPv3 Ethernet .
The L2TPv3 Ethernet page appears.
3. To view configuration details about an NEMO tunnel, click the
­
(configuration) icon in the
upper right of the tunnel's status pane.
Command line
1. Log into the AnywhereUSB Plus command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. To display details about all configured L2TPv3 Ethernet tunnels, type the following at the
prompt:
> show l2tpeth
Tunnel Session Enabled Device Status
----------------- ------- ------------ ------
test/session/test true le_test_test up
>
3. To display details about a specific tunnel:
> show l2tpeth name /vpn/l2tpeth/test/session/test
test/session/test Tunnel Session Status
---------------------------------------
Enabled
: true
Status : up
Local IP : 4.3.2.1
Remote IP : 10.10.10.1
Tunnel ID : modem
Peer Tunnel ID : 10.10.10.1 === 4.3.2.1
Session ID : 255
Peer Session ID : 1476
Lifetime (Actual) : 600
Device : le_test_test
RX Packets : 2,102
RX Bytes : 462
TX Packets : 2,787
TX Byptes : 3,120
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.