Digi AnywhereUSB Plus, Руководство пользователя, Страница: 485 / 815

Diagnostics Analyze network traffic
AnywhereUSB® Plus User Guide 485
a. For Run mode , select the mode that will be used to run the capture filter. Available
options are:
n
On boot : The capture filter will run once each time the device boots.
n
Interval : The capture filter will start running at the specified interval, within 30
seconds after the configuration change is saved.
l
If Interval is selected, in Interval , type the interval.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format
number { w|d|h|m|s }.
For example, to set Interval to ten minutes, enter 10m or 600s .
n
Set time : Runs the capture filter at a specified time of the day.
l
If Set Time is selected, specify the time that the capture filter should run in Run
time , using the format HH : MM .
n
During system maintenance : The capture filter will run during the system
maintenance time window.
b. Enable the capture filter schedule.
c. For Duration , type the amount of time that the scheduled analyzer session will run.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format
number { w|d|h|m|s }.
For example, to set Duration to ten minutes, enter 10m or 600s .
d. For Save interval , type the frequency with which captured events will be saved.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format
number { w|d|h|m|s }.
For example, to set Save interval to ten minutes, enter 10m or 600s .
9. Click Apply to save the configuration and apply the change.
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a new capture filter:
(config)> add network analyzer name
(config network analyzer name )>