Digga Magnum II Series, Руководство оператора и каталог запасных частей

Страница: 28 / 56

28
BREAK-IN PERIOD
Procedure
After First
8 Hours
After First
16 Hours
After First
40 Hours
After First
120 Hours
Check drive belt tension.
   
Check torque on taper-lock bushing set
screws. (#113757 to 67 ft. lbs. and #113594
to 84 ft. lbs.)
 
Change oil in overhung load adapter.

NOTE:
Repeat Break-In Period whenever belt, sprockets or overhung load adapter is replaced.
LUBRICATION SPECIFICATIONS
Lower bearings NLGI grade 2 lithium grease without graphite or molybdenum additives.
Overhung load adapter Synthetic ISO 150 gear lube without graphite or molybdenum additives.
(approximately 16 oz. capacity)
LUBRICATING LOWER BEARINGS
Lubricate lower bearings with 2-3 pumps of grease every 200 hours. Over lubricating will cause
premature bearing failure.
NOTE: The right bearing lubrication fitting is located on the top of the drive belt housing compartment
along with a grease relief vent plug. The left bearing lubrication fitting is located on the bearing
housing along with a grease relief vent plug. Normal pressure build-up during operation may result in
grease escaping from relief vent plugs. Continue lubricating at specified intervals.
WARNING!
ESCAPING FLUID UNDER PRESSURE CAN HAVE SUFFICIENT FORCE TO
PENETRATE THE SKIN, CAUSING SERIOUS PERSONAL INJURY. FLUID
ESCAPING FROM A VERY SMALL HOLE CAN BE ALMOST INVISIBLE. USE A
PIECE OF CARDBOARD OR WOOD, RATHER THAN HANDS, TO SEARCH FOR
SUSPECTED LEAKS.
KEEP UNPROTECTED BODY PARTS, SUCH AS FACE, EYES, AND ARMS AS
FAR AWAY AS POSSIBLE FROM A SUSPECTED LEAK. FLESH INJECTED WITH
HYDRAULIC FLUID MAY DEVELOP GANGRENE OR OTHER PERMANENT
DISABILITIES.
IF INJURED BY INJECTED FLUID, SEE A
DOCTOR AT ONCE. IF YOUR DOCTOR IS
NOT FAMILIAR WITH THIS TYPE OF
INJURY, ASK HIM TO RESEARCH IT
IMMEDIATELY TO DETERMINE PROPER
TREATMENT.
CARDBOARD
MAGNIFYING GLASS
HYDRAULIC HOSE
OR FITTING
MAINTENANCE & SERVICE
PM-000102-A OCTOBER 2017 27