27
EXERCISE THE MANDATORY SAFETY SHUTDOWN PROCEDURE BEFORE
WORKING ONOR AROUND THE MULCHER.
Procedure
Daily
Every
40
Hours
Every
120
Hours
Every
200
Hours
Every
1000
Hours
Case Drain Coupler - Check for complete
engagement of coupler.
Check for kinked or pinched hoses. Reroute as
required.
Hydraulic Oil - Check prime mover hydraulic
system for adequate oil levels.
Hardware - Check for tightness (see Bolt Torque
Specifications)
Hardware - Replace any missing or damaged
bolts or nuts with approved replacement parts.
Hydraulic System - Check for leaks and tighten as
necessary. Check for damage and replace as
needed.
Decals - Check for missing or damaged safety
decals and replace as necessary.
Teeth - Replace worn, damaged or missing teeth.
Inspect attachment for any worn parts or cracked
welds. Repair as required.
Clean rotor of any accumulated debris and dirt.
Clean internal mulcher compartments, including
drive belt housing area.
Check drive belt tension.
Check oil level in overhung load adapter. (See
maintenance instructions.)
Lubricate rotor bearings 2-3 pumps.
Over
lubricating will cause premature bearing
failure.
Change oil in overhung load adapter. (See
maintenance instructions.)
IMPORTANT:
When replacing parts, use only factory approved replacement parts. The Manufacturer
will not claim responsibility for use of unapproved parts or accessories and or other damages as a result
of their use.
MAINTENANCE & SERVICE
GENERAL INFORMATION
Regular maintenance is the key to long equipment life and safe operation.
Maintenance requirements have been reduced to an absolute minimum. However it is very
important that these maintenance functions be performed as described
below.
WARNING! NEVER DO ANY MAINTENANCE TO THE MULCHER WHILE IT IS RUNNING.
PM-000102-A OCTOBER 2017
26
Содержание Magnum II Series
Страница 2: ......
Страница 56: ...Australian Designed and Manufactured PM 000102 A...
