DFI LanParty UT NF590 SLI-M2R/G, Руководство пользователя

Страница: 76 / 162

7 6
3
BIOS Setup
IDE HDD Auto-Detection
Detects the parameters of the drive. The parameters will automati-
cally be shown on the screen.
The settings on the screen are for reference only. Your version may not be
identical to this one.
Primary IDE Master/Slave to Internal Phy SATA 1/2/3/4/5/6
Primary IDE Master
Primary IDE Slave
Internal Phy SATA 1
Internal Phy SATA 2
Internal Phy SATA 3
Internal Phy SATA 4
Internal Phy SATA 5
Internal Phy SATA 6
Note:
The fields for configuring Serial ATA drives (“Internal Phy SATA 1”
to “Internal Phy SATA 6”) will appear only if the “Serial-ATA
Controller” field is set to Enabled. This field is in the Genie BIOS
Setting - PCI Device Control - RAID Config section of the BIOS.
IDE HDD Auto-Detection
Primary IDE Master
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
Phoenix - AwardBIOS CMOS Setup Utility
Primary IDE Master
Item Help
Menu Level
XX
To auto-detect the
HDD’s size, head... on
this channel
↑↓→←
: Move Enter: Select F1: General Help +/-/PU/PD: Value F10: Save ESC: Exit
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
0
0
0
0
0
Press Enter
Auto
Auto
0 MB
Used to configure Parallel ATA drives
Used to configure Serial ATA drives
To configure IDE drives, move the cursor to a field then press
<Enter>. The following screen will appear.