DFI LanParty UT NF590 SLI-M2R/G, Руководство пользователя, Страница: 45 / 162

45
2
Hardware Installation
W
S/PDIF-in/out Jacks
The system board is equipped with an onboard S/PDIF-in RCA jack
(red) and a S/PDIF-out RCA jack (yellow) at locations CN5 and
CN7 respectively.
The S/PDIF connector at location J3 is used to connect optical
S/PDIF por ts. The S/PDIF ports may be mounted on a card-edge
bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable connector to J3.
Make sure pin 1 of the audio cable connector is aligned with pin 1
of J3.
Important:
DO NOT use optical S/PDIF and coaxial RCA S/PDIF at the
same time.
W
Optical
S/PDIF
1
5
+5V
Key
SPDIF out
SPDIF in
GND
S/PDIF-in
S/PDIF-out