DEUTZ-FAHR MP135 R, Руководство по эксплуатации

Страница: 27 / 62

25
EN
16652807_en 05/2006
To check and correct the length, proceed as follows:
z
hitch the round baler to the tractor,
z
drawbar must be set as described in Section 4.3,
z pull apart the universal drive shaft and mount the
halves to the tractor and machine,
z hold the universal drive shaft halves under each
other,
z when taking all curves and when driving straight,
ensure that:
-
a minimum overlap of b = 200 mm is
guaranteed,
- the universal drive shaft is not sitting on the
block, minimum distance a = 20 mm,
- there is sufficient clearance between the
drawbar and the universal drive shaft.
z
if it is necessary to shorten the length, saw the same
amount off both the sliding and protective tubes.
z
carefully burr the pipe ends, remove shavings
and grease sliding points well.
4.5 Set baling pressure
The bale density of a round bale depends on the quality
of the crop and the set baling pressure. Baling pressure
is regulated hydraulically. By turning the adjusting
wheel of the control valve to the right, the baling
pressure is increased, and the baling pressure is
reduced. Pressure can be set to a maximum of 170
bar. (The system design means that a pressure loss of
approx. 10% is possible because of thermodynamic
processes in the accumulator)
When making t When making t When making t When making t When making the basic se he basic se he basic se he basic se he basic setting, pr tting, pr tting, pr tting, pr tting, proceed as f oceed as f oceed as f oceed as f oceed as follo ollo ollo ollo ollow w w w ws: s:s: s: s:
z set the control valve for the tailgate to ‘lower’ while
the tractor is running
z the preset pressure set can be read off the
manometer on the press
z by turning the adjusting wheel, the baling pressure
can now be set and be directly read off the
manometer. It is easier to turn the adjusting wheel
when the system is not under pressure.
Start adjustment at low pressure level (knurled
screw unscrewed). No direct pressure display
possible during re-adjustment.