DEUTZ-FAHR MP135 R, Руководство по эксплуатации

Страница: 33 / 62

31
EN
16652807_en 05/2006
Pr Pr Pr Pr Prog og og og ogrrrrramming t amming t amming t amming t amming the aut he aut he aut he aut he automatic cutting knif omatic cutting knif omatic cutting knif omatic cutting knif omatic cutting knife eng e eng e eng e eng e engagement agement agement agement agement:::::
When 90% of the preselected bale density has been
reached the buzzer creates an intermittent audible
warning. That means that the cutting knives are
engaged for three seconds (the buzzer sounds
throughout the duration of the cutting action). Using
the single acting control unit it is possible to disengage
the knives during the three seconds (actuate the control
unit until the audible warning stops!). To program the
automatic knife engagement before the next baling
cycle, follow the procedure below:
z Press program button (9)
z Press button (1) until the screen displays the
desired indication „CUT 1“ = active or „CUT 0“ =
inactive
„1“ If the knives are manually disengaged as
described above, knives are automatically
re-engaged after the bale is completed and
the tailgate closed.
„0“ If the knives are manually disengaged as
described above, knives are NOT
automatically re-engaged. To re-engage the
knives it is necessary to select the function
„switching the cutting mechanism on and
off“ (button 1) and to actuate the control unit.
z Use program button (9) to save the adjusted mode.
While the blades are being swivelled out, the float
position for the pick up is blocked. Bring the control
lever back into the float position after the swivelling
stage!
A A
A A Adjus
djus
djus djus djusting t
ting t
ting t ting t ting the y
he y
he y he y he yar
ar
ar ar arn edge clear
n edge clear
n edge clear n edge clear n edge clearance
ance
ance ance ance
z
Press programme button (9)
z
Press edge clearance button (3). Press several
times to select the edge clearance in the following
graduations: 120, 150, 180, 210 (the adjustment
is made automatically for both sides)
z For the minimum clearance (120), the number
of hoops on the outside is approx. 1.5, or approx.
2.5 for maximum clearance (210)
z Then press programme button (9)
A
1
9
PROG PROG PROG *)
*) RESET = POWER OFF-ON + PROG + C
PROG
AUTO
A
3
9
PROG PROG PROG *)
*) RESET = POWER OFF-ON + PROG + C
PROG
AUTO