26
EN
16652807_en 05 /2006
4.6
Setting pick-up
4.6.1 Setting pick-up height
The pick-up is raised and lowered hydraulically using
the tractor control unit. To do this, the ‘pick-up’ function
must be preselected at the "Autoform" (LED on).
The working height of pick-up is set using two feeler
wheels (right and left).
The height at which material is lifted up cleanly is to be
set in accordance with the ground conditions and the
quality of the baling material.
The distance between the tine tips at their lowest position
and the ground is the decisive factor. Indicative values
here are a minimum clearance of a=2 cm for green
crops and hay, or a maximum clearance of a=7 cm
for straw. The tines should not come into contact with
the ground to prevent the baling material becoming
dirty and above-average wear of the tines.
The distance between the tines and ground is set using
2 x 6 borings at the feeler wheel rod (b). Ensure that
the setting at the right and left feeler wheels is the same.
4.6.2 Setting pick-up unload
The ground pressure of the pick-up above the feeler
wheels can be set using the right and left compensation
spring (a). The springs are pushed by the hydraulic
cylinder of the pick-up lift. Unload can be preset by
selectively inserting the sliding clips (b) into one of the
four positions.
Stronger unloading (foremost groove in direction of
travel) for soft ground or gentler unloading (furthest
groove back in direction of travel) for hard ground and
‘jump’ for pick-up when the ground is not level.
To insert the sliding clips into different grooves, the pick-
up must be raised to the limit.
a
b
Содержание MP135 R
