39
EN
16652807_en 05/2006
5.3.2.2 MP/RF 135 OC23 „Autoform“
·
Press pushbutton (1) to activate the ‘cutting
mechanism’ function.
·
Operate the tractor spool valve to run the knives
out (pressure onto the (+) side) or in (pressure
onto the (-) side).
·
If the dot under the knife symbol (A) becomes
illuminated, that means that the knives are
swung out, but are inoperative.
·
If the knives are retracted again, operate the
hydraulic system 2-3 seconds longer to allow
the diaphragm of the pressure accumulator to
be filled.
Note
Knives will swing out faster if this step is
performed during the collection of crop.
5.3.2.3 Variable knife engagement in
groups
The 23 knives of the OptiCut cutting mechanism can
be engaged in different groups. Two ball cocks located
on the hydraulic block on the left hand side of the
machine can be used to move by choice 0, 11, 12 or
23 knives to operating position.
Procedure:
Procedure:
Procedure:
Procedure:
Procedure:
1.
Open both ball cocks (23).
2.
Operate the tractor control valve to swing out
the knife engaging system.
3.
Close the ball cock for the desired knife group.
4.
Give pressure onto the tractor control valve to
engage the desired knife group.
Possible knife engagement options:
Possible knife engagement options:
Possible knife engagement options:
Possible knife engagement options:
Possible knife engagement options:
0
All knives disengaged
11
11 knives of group 1 engaged.
Cutting length: abt. 90 mm
12
12 knives of group 2 engaged.
Cutting length: abt. 90 mm
23
All knives engaged.
Cutting length: abt. 45 mm
>>
1
2
3
4
A
Pickup Schneidwerk keine Funkti-
on
A
PROG
PROG
PROG
*)
*) RESET = POWER OFF-ON + PROG + C
PROG
1
0
11
12
23
Содержание MP135 R
