DEUTZ-FAHR MP135 R, Руководство по эксплуатации

Страница: 29 / 62

27
EN
16652807_en 05/2006
4.6.3 Set pick-up baffle plate
The function of the baffle plate is to hold down the
baling material in order to achieve an even flow of
material. The height of the baffle plate can be adjusted
using two chains to suit the type of material and its
volume.
4.6.4 Pick-up overload protection feature
In order to prevent damage, the pick-up is equipped
with a torque protector in the drive mechanism. When
there is overloading, the power flux is interrupted by
the breaking of shear bolt M8 x 45 8.8 DIN 931 (a)
and pick-up stops. When shear bolts are being
changed, only top quality bolts are to be used.
4.7 Setting scrapers
To prevent twine from emerging between the ridged
rollers in the area extending from the twine feed into
the chamber to the material feed opening, plastic
scrapers are mounted on the machine. They are set in
such a way that the revolving rollers lightly touch the
entire width or project a maximum of 1 mm into the
roller orbit. Adjustment is possible by loosening the bolt
connections on the side walls and re-positioning the
scraper edges. Finally, all bolt connections must be re-
tightened.
4.8 Shearing screws roller drive
In order to avoid damage to the rollers, two shearing
screws M8 x 45 DIN 931 10.9 act as main safeguard
(one each in the front and rear half of the baling
chamber) in the roller drive. Both shearing screws are
located in the double chain drive on the left-hand side
of the machine at the front. Should the shearing screws
brake, the corresponding hole position can be found
using the reverse lever (set to hexagon).
a