Derbi ATV DXR 200, Руководство по ремонту

Страница: 62 / 194

61
4-3. E
NGINE
R
EMOVAL
/I
NSTALLATION
S
ERVICE
I
NFORMATION
CAUTION
1. WHEN REMOVING ENGINE, A FIRM ENGINE STAND IS REQUIRED TO SUPPORT THE ENGINE. BE SURE DO
NOT USE HAMMER OR SCREW DRIVER TO STRIKE OR PRY THE ENGINE. DO NOT DAMAGE THE CRANKCASE
MATTING SURFACES AND CLEAN OFF ALL GASKET MATERIAL FROM THE MATING SURFACES.
2. AFTER CRANKCASE ASSEMBLY, CHECK TRANSMISSION SYSTEM OPERATION
SMOOTHLY. AND THEN START ENGINE AND CHECK THE LUBRICATION
SYSTEM IS WORKING NORMALLY.
3. ENGINE OIL CAPACITY: 1.1 L AT DISASSEMBLY
1.0 L AT CHANGE
4. THE TORQUE VALUES:
1). ENGINE BRACKET BOLT: 2.0 - 2.5 KGM
2). DRIVE GEAR LOCK BOLT: 0.8 - 1.2 KGM
3). EXHAUST MUFFLER HANGER LOCK BOLT: 2.4 - 3.0 KGM
4). EXHAUST PIPE JOINT LOCK NUT: 0.8 - 1.2 KGM
4-3 1. Engine removal
Be sure to turn off- the fuel clock (Fig. 4•23)
01. remove the carburettor Fig. 4-24
02. disconnect the clutch cable Fig. 4-25. 4-26
03. remove the exhaust pipe Fig. 4-27, 4-28, 4-29, 4-30
03. remove the spark plug cap Fig. 4-31
04. turn the fuel cap off and disconnect the fuel cube
05. disconnect the generator wire connector Fig. 4 32
WARNING
ATV WITH IMPROPER MODIFICATIONS.
AWARENESS
Improper installation of accessories or modification of this ATV may change ATV handling condition which
could lead to an accident.
SOLUTION
1. Never modify this ATV through improper installation or use of accessories.
2. All parts and accessories added to this ATV should be genuine maker or equivalent components designed
for use on this ATV and should be installed and used according to instructions.