Derbi ATV DXR 200, Руководство по ремонту

Страница: 152 / 194

151
11. After clamping, check each harness to make sure that it is not interfering with any moving or sliding parts
(Fig. 6-11).
12. When fixing the wire harnesses, do not make it contact with the parts which generate high heat (Fig.
6-12).
13. Route the wire harnesses to avoid sharp edges or corners. Avoid the projected ends of bolts and screws.
Route the wire harnesses passing through the side of bolts and screws. Avoid the projected ends of bolts and
screws (Fig. 6-13).
14. Route the harnesses so they are neither pulled the tight nor have excessive slack (Fig. 6-14).
15. Protect wires and harnesses with electrical tape or tube if they come in contact with a sharp edge or
corner (Fig. 6-15).
16. When the rubber protecting covers are used to protect the wire harnesses, they shall be installed securely
(Fig. 6-16).
17. Do not break the sheath of the wire. If a wire or harness has a broken sheath, it can be repaired by
wrapping it with a protective tape or replacing it.
18. After routing, check that the wire harnesses are not twisted or kinked (Fig. 6-17)
19. wire harnesses routed along the handlebar should not be pulled tight, have excessive slack or interfere
with adjacent or surrounding parts in all steering positions.
20. When a testing device is used, make sure to understand the operating methods thoroughly and operate
according to the operating instructions (Fig. 6-18) .
22. Be careful not to drop any parts.
23. When rust is found on a terminal, remove the rust with sand paper or equivalent before connecting (Fig.
6-19) .
24. Do not bend or twist the control cables. Damaged control cables will not operate smoothly and may stick
or bind (Fig. 6-20).