Derbi ATV DXR 200, Руководство по ремонту

Страница: 170 / 194

169
<continue de 6-4-5 Assembly>
05. apply a thin coat of grease to the front cover oil seal and bearing.
06. install the special washer and the front cover to the motor body and do not damage the oil seal.
07. after the front and rear covers are installed, the punch marks must aligns each other.
08. install and tighten the case bolts.
* Torque: 0.8-1.2 kg -m
09. after assembly, check the starter motor for proper operation.
6-4-6. Starter relay inspection (Fig. 6-41, 6-42)
01. remove the cover.
02. Turn ignition switch ON and then press the starter button.
03. The starter relay is normal to hear a “clicking” sound.
If there is no clicking sound (Fig. 6-41)
1). Inspect the starter real voltage.
2). Inspect the starter relay ground circuit.
3). Check for continuity between the starter relay wires. (Fig. 6-42)
04. Connect the starter relay wires to a 12V battery (Fig. 6-42A)
05. Connect the starter motor terminals to an electric tester and check for continuity between the terminals
(Fig. 6-42A)
06. Replace the starter relay with a new one if there is no continuity (Fig. 6-42A).
6-4-7. Starter motor installation
01. apply engine oil to the starter motor O-ring and then install the O-ring.
02. Install and tighten the two mounting bolts.
03. install the starter motor wire lock nut and rubber cover.