Derbi ATV DXR 200, Руководство по ремонту

Страница: 10 / 194

9
PART 1. GENERAL INFORMATION
1-1. S
ERVICE
P
RECAUTIONS
01. Be sure to use the new gaskets, o-rings, ring clamps, cotter pins... during the re-assembly or any service.
(Fig. 1-01).
02. When tightening bolts, screws, or nuts, should start with large diameter boles to smaller ones. Be tighten
to the specified torque diagonally. (Fig. 1-02)
03. Only use genuine parts and lubricants as Maker’s suggestion (Fig. 1-03)
04. On servicing vehicle, be sure to use the special or common tools (Fig. 1.04)
05. After disassembly, be cleaned all the removed parts. Lubricate sliding surfaces with engine oil on engine
parts before reassembly (Fig. 1-05).
06. Apply designated greases and lubricants to the specified lubrication points. (Fig. 1-06)
07. After reassembly, check all parts for proper tightening and operation. (Fig. 1-07)
08. Disconnect battery negative (-) terminal before operation. (Fig. 1-08)
09. When connecting the battery, the positive (+) terminal should be connected first. After connection, apply
grease to battery terminals. The terminal caps shall be installed securely. (Fig. 1-09)
10. If the fuse is burned out, only replace the new fuse with the specified capacity. (Fig. 1-10)
11. When using a spanner or other tools, make sure not to damage the vehicle’s surface.
12. After service operation, check all connecting points, fasteners and lines for proper connection and
installation.
PART 1. GENERAL INFORMATION