Denon AVR-2105, Руководство по эксплуатации

Страница: 14 / 296

14
ENGLISH
Check of the measurement results
1
Select the items.
The measurement results of each item can be checked
here.
A.Set SpConf.Ck
(Remote control unit)
2
Press the ENTER button and display the verification screen.
(Remote control unit)
[Speaker Config. Check] [Delay Time Check] [Channel Level Check]
NOTE:
• When measurements have been made using the measurement microphone,
speakers with a built-in filter such as subwoofers might be set with a value
that differs from the physical distance because of the internal electrical delay.
3
If the check ends, press the ENTER button again.
(Remote control unit)
4
Select from the following three items based on the
measurement results.
• Store : Set with the checked measurement
value.
• Retry : Perform the measurement again.
• Cancel : Cancel the checked measurement
value.
A.Set <Store
(Remote control unit)
5
When the “Store” is selected, all parameters are
stored up and switch to the SUBWOOFER MODE
setting.
(Remote control unit)
Setting the type of speakers
1
Set whether or not speakers are connected and, if so, their size parameters.
2 FRONT LARGE
2
Press the ENTER or (down) button to enter the settings and switch to the
SPEAKER DISTANCE setting.
• Set up in function of your speaker systems. Performing this setup optimizes the system.
• The composition of the signals output to the different channels and the frequency response are adjusted
automatically according to the combination of speakers actually being used.
Center Sp. Front Sp. Front Sp.
Listening position
Surround back Sp.
Subwoofer
Surround Sp.
Surround Sp.
• To select the parameter
• Parameters
Large.................Select this when using speakers that have sufficient performance for reproducing bass sound
below the frequency set for the Crossover Frequency mode.
Small .................Select this when using speakers that do not have sufficient performance for reproducing bass
sound below the frequency set for the Crossover Frequency mode. When this is set, bass
sound with a frequency below the frequency set for the Crossover Frequency mode is sent
to the subwoofer.
None .................Select this when no speakers are installed.
Yes/No...............Select “Yes” when a subwoofer is installed, “No” when a subwoofer is not installed.
2spkrs/1spkr .....Set the number of speakers to be used for the surround back channel.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when
“Small” is set for the front, center and surround speakers.
(Remote control unit)
(Remote control unit)
• To select the speaker
(Remote control unit)