DeLuxe Stitcher IMSHP-A25, Руководство по эксплуатации и обслуживанию

Страница: 9 / 56

7
cradle. Make sure that the wire payoff is from the top of the spool, as shown in Figure 2 . The Wire
Guide Spring (MG10009A) slides into the slot in the Wire Guide Spring Bracket (MG10001A) on
the top of the Head located at the front of the machine.
Once the assembly is complete, turn the machine over by hand a few times using the Shaft Extension
Handle (PG10211) located at the rear of the unit. All parts must operate freely before turning on the
power. Push and turn the handle counter-clockwise (looking from the rear of the machine) to
manually rotate the machine. You are ready to plug in your MiniStitcher, but do not turn on the
main power yet.
Before the machine is turned on, raise the Head
Guard (PG10003), disengage the Swivel
Operating Spring (9046A) and remove the Swivel
Assembly (9038M or 9038A). Thread the wire
from the Spool (refer to
Figure 2
for the correct
wire payoff) through the Wire Guide Spring
(MG10009A), between the flanges of the Wire
Straightener Rollers (9103) on the Wire Guide
Spring Bracket (MG10001A) as well as between
the Wire Straightener Bushing (9068) and the
Wire Straightener Rollers (9103) on the Face
Plate (2132BA). Continue to pull the wire
through the Tension Pawl (9098), through the
hole in the Face Plate in the top of the Wire
Cutter (9048) Holder and through the Swivel
Holder (9043B). At this point, do not worry if
the wire is not fed between the Grip (9015) and
the Grip Holder area.
Note: The Tension Pawl will hold the
wire in the groove in the Wire Straightener
Roller (9103). This will allow the wire to
feed through the Head but not allow it
to “back-up.”
Pull enough wire through the bottom of the
Head to clear away what was bent in the
Figure 3 - Wire Threading
Operation
Wire Threading (Figure 3)
MG1009A
MG10001A
9103 (2)
9068
2132BA
9046A
9103 (3)
9098
9015
9048
9043B
9038M or
9038A