DeLuxe Stitcher IMSHP-A25, Руководство по эксплуатации и обслуживанию

Страница: 49 / 56

47
For those applications which require it, a Work Table Kit (IMSK3) is available for the MiniStitcher.
Call your DeLuxe Stitcher Graphic Arts Representative for more information.
In order to mount the ISMK3 Work Table Kit onto the MiniStitcher, complete the following steps.
Remove the Table Base (MG10180) from the bottom of the stitcher by removing the four (4) Screws
(UA6116.1) and Washers (LW12.2 and PW14). Lay the stitcher on its side with the Clincher Arm
hanging off the edge of a table. Slide the Work Table (MG10160A) over the Clincher Arm from the
front until the Solid Clincher (MG10178) is aligned with the rectangular hole in the Table. The slots
in the Work Table should also align with the threaded holes in the Clincher Arm. Place each of the
four (4) Screws (UA4810.1) provided through the slot, through the Spacer (MG10159) and into the
Clincher Arm. Before tightening these Screws, raise the Table until it is even with the top of the Solid
Clincher and it is level.
IMSK3 (Figure 18)
!
Always disconnect the power cord before
assembling the MiniStitcher or making any adjustments.

CAUTION
!
Figure 17 - IMSK3 Work Table Kit
MG10160A
MG10105 (2)
PG10244 (2)
MG10159 (4)
UA4810.1 (4)
MG10402